LOKSET® SPIN TO STALL RESIN CAPSULES

LOKSET® SPIN TO STALL.

Lokset capsules are filled with a reinforced thixotropic polyester resin in one compartment and a catalysed mastic filler in the other, separated by a physical barrier. The rotation of the bolt during installation ruptures the capsule, shreds the skin and mixes the two components causing a chemical reaction and transforming the resin mastic into a solid anchor. 

The capsule is available in 50:50 ratio of fast: slow speeds

Product Image
Advantages
  • FAST SETTING, EASY TO USE
  • SHORT INSTALLATION TIME
  • QUICK, HIGH LOAD TRANSFER
Features
  • Rapid insertion, easy and quick to use
  • Shorter installation times with no hold time required
  • Easy to install, requiring no specialty injection equipment
  • Resistant to anchoring failure caused by blasting or vibration
  • Rapid anchoring of the bolt to the surrounding strata
  • High load transfers achievable almost immediately
  • Full column bonded bolts strongly resist the horizontal and lateral strata movement associated with convergence
  • Provides strength and rigidity to prevent sag
  • Acts as a reinforcement that clamps the individual strata layers into a single high strength beam
  • Effectively seals wet, dripping holes and in most cases eliminates deterioration of the hole and surrounding strata
  • Unaffected by sea or fresh water, mild acids or mild alkaline solutions
  • Immediately fixes rock bolts / anchors
  • Protects bolts from corrosion, can be used in wet/underwater condition

Configurations

CAPSULE SPEED CAPSULE CODE RATIO SPIN TIME*
FAST/ SLOW FS 50:50 12-15 s
Typical insertion properties at 25°C * Approximate spin time in seconds
Product Options
  • Lokset Spin to Stall - SKU NF0000460, 1,000mm L x 25mm D, 4 month shelf life
  • Lokset Spin to Stall - SKU NF0000461, 1,200mm L x 25mm D, 4 month shelf life
  • Lokset Spin to Stall - SKU NF0000462, 1,400mm L x 25mm D, 4 month shelf life