It is a one-component material, which after mixing at the site of application with the appropriate amount of water (water/powder ratio of range 1:1 to 2:1), sets to a durable concrete material.
Upon exiting the pump, the material is liquid and thus it is able to fill any roughness and gaps. Tekblend H gels after about 10 minutes depending on the preparation method.
It is supplied as a ready to use blend of dry powders which requires only the addition of clean water to produce a highly compacted, rapid setting mortar which is easy to apply.
The material is based on a blend of cements, graded aggregates, special fillers and chemical additives which control the rate of set and minimise the risk of shrinkage cracking.
A one component material which after mixing at the site of application with the appropriate amount of water (water/powder ratio of 1:1 to 4:1) sets to become a durable concrete material.
The material, upon exiting the pump, is liquid and thus it is able to fill any roughness and gaps. Tekblend gels after about 3 minutes depending on the preparation method.
Tekblend is commonly applied in:
- building of monolithic packs for the protection of longwall galleries
- building of ventilation and explosion resistant seals
- building of isolation and backfill walls
- filling voids (cavities) above mining excavation roof support
- eliminating voids outside of mining excavation roof support
- filling backfill voids
- sealing of galleries
We offer two different products within this category, that vary in setting speeds and application area.
Minobond AM is an anchoring mortar used for the grouting of steel parts in horizontal and vertical concrete surfaces and the filling of scratches, cracks, joints and deficiencies of concrete.
Minobond APS is a single component highly fluid rapid setting grout, designed especially for APS sewer manhole repair, whilst it is also used for filling backfill voids.